How to brushing to filter in a co-display chart
Hello all,
As I know, to create a report contains more than one chart, we had 3 solutions are "Dashboard", "Co-Display" and "Canvas" reports.
My requirement related to above reports are as below:
1. Create a report contains more than one chart with a scatter chart included, example "my report"
2. Have "another report" drill through to "my report"
3. If the users select one or more scatters in scatter chart, they should see other charts in "my report" refreshed just for the data corresponding to the scatter(s) they selected in the scatter plot
Question 1: Can we create a "co-display" or "canvas" report adapt to above requirement?
Question 2: If we must use "dashboard" report in this case, how can we setup "drill through" from "another report" to "my report"?
Thank you for the support.
The same question
Hello Nam,
Thanks for reaching out with your question. Keep in mind that with brushing, there are some chart limitations, these can be found at the bottom of our Wiki Page on brushing. You only have one option to link chart brushing, and that's by using the 'Anlaytic Setup' in a dashboard. It's not possible to drill through from a report to a dashboard unfortunately. Additionally, mult-chart, "canvas", reports don't allow brushing. A "co-display" report can be drilled to, but doesn't support brush linking.
In short, you're scenario comes up on two limitations that prevent this exact layout. I feel the best you can do here is create one full dashboard, link the filters, and then link the brushing. This is all done through analytic setup.
Does that answer your question?
Thanks,
Ryan
Hello Nam,
Thanks for reaching out with your question. Keep in mind that with brushing, there are some chart limitations, these can be found at the bottom of our Wiki Page on brushing. You only have one option to link chart brushing, and that's by using the 'Anlaytic Setup' in a dashboard. It's not possible to drill through from a report to a dashboard unfortunately. Additionally, mult-chart, "canvas", reports don't allow brushing. A "co-display" report can be drilled to, but doesn't support brush linking.
In short, you're scenario comes up on two limitations that prevent this exact layout. I feel the best you can do here is create one full dashboard, link the filters, and then link the brushing. This is all done through analytic setup.
Does that answer your question?
Thanks,
Ryan
Replies have been locked on this page!