Category
Report Builder
Product Version
7.2
Extra Filter in Report Based on Stored Procedure Doesn't Obey Mandatory Option
Completed
I added an extra filter to a report based on a stored procedure. I made sure the option to make it mandatory was set to off; however, when running the report it treats it as mandatory. As a workaround, I turned the filter into a list selection.
v7.2 b20161205
The same problem 
Hi Jason,
I have been able to replicate the issue you described so I have raised a defect in order for it to be fixed, the defect ID is YSD-735 and at present there is no ETA for it. I searched for another workaround for you, but yours is the best.
Thanks for letting us know about this, and apologies for the inconvenience caused.
regards,
David
Hi Jason,
I have been able to replicate the issue you described so I have raised a defect in order for it to be fixed, the defect ID is YSD-735 and at present there is no ETA for it. I searched for another workaround for you, but yours is the best.
Thanks for letting us know about this, and apologies for the inconvenience caused.
regards,
David
Replies have been locked on this page!